I-hook uhlobo shot ukuqhumisa umshiningokuvamile inokubukeka okukhudlwana, futhi inqubo yokufaka iyinkimbinkimbi kakhulu kunaleyo yemishini emincane. Ukufakwa okulungile nomshini wokuhlola kuyisihluthulelo sokuqinisekisa ukusebenza okujwayelekile kwemishini yakamuva. Endabeni yokusebenza kokuqala okungenamakhono, abasebenzisi kudingeka ukuthi balandele ngokuqinile imiyalo yabasebenzi abafanele noma babheke kumiyalo. Ukusebenza okungagunyaziwe kungadala umonakalo ongalungiseki kuhook shot ukuqhumisa umshini. I-shot blasting machine manufacturer has sorted out the precautions for installation and test machine to share with you. I hope it will be helpful to users who use the device for the first time.
1. Installation. I-hook uhlobo shot ukuqhumisa umshini is installed and debugged in the production plant and disassembled into several parts before being transported to the user site for installation. Although there is no pit, the foundation must be firm, the anchor bolt holes must be standardized, and the chamber body must be adjusted. After the second irrigation, the anchor bolt nuts can be tightened after solidification. After the chamber body is fixed, the various parts can be installed. I-precautions for the installation and debugging of the relevant components are introduced below.
1.Idivayisi yokuqhuma:
I-shot blasting device has been installed on the chamber body before leaving the factory. Please pay attention to the problems to be debugged before use. Check whether the fixed positions of the blade, the pill wheel, the directional sleeve, and the guard plate are accurate and firm, and check whether the direction of rotation is correct after power on. Then adjust the position of the directional sleeve opening. Theoretically, the angle between the front edge of the directional opening and the front edge of the blade throwing position is about 900. After fixing the position of the directional sleeve, the position of the projectile belt can be detected by hanging Place a steel plate or wooden board on the position of the workpiece facing the exit of the shot blasting machine, start the shot blasting machine, put a small amount (2-5kg) of projectiles into the blasting tube, and then stop, check whether the hit position on the steel plate is suitable for the needs, such as Close the window of the bias-adjustable directional sleeve downwards, and vice versa, until it fits, and note the position of the directional sleeve opening as a basis for future replacement of the directional sleeve.
2.Mphakamisa futhi isikulufa elihambayo:
Okokuqala yenza isivivinyo sokungalayishi ukubheka ukuthi ingabe ibhakede lokuphakamisa kanye namabhande okuvunguza asebenza ngendlela efanele yini, bese uqinisa ibhande le-hoist ngezinga elilinganisiwe lokungezwani ukugwema ukuphambuka, bese wenza isivivinyo somthwalo ukubheka ukusebenza namandla adlulisayo, noma ngabe kukhona umsindo oxakile nokudlidliza, hlola futhi ususe izithiyo.
3. Isihlukanisi sephilisi-isihlabathi:
Okokuqala hlola ukuthi ukunyakaza kwenqama kuyavumelana nezimo, bese ubheka ukuma okufanele kwepuleti elihlukanisayo, lapho-ke lapho ukuphakamisa kulayishwa futhi kulungiswe iphutha, kunokugeleza okuqhubekayo kokudutshulwa kwensimbi, bese uhlola ukuthi isibhamu sensimbi siyaphuma futhi siyawa yini lapho ukhishwa ukhishwa